Keystone Jack, Category 6A, RJ45/s

P/N: KEJ-C6A-S-10G
  • tool-free, fast and easy installation 
  • enables transmission of all high-speed protocols including 10GBASE-T 
  • guarantees a bandwidth of 500 MHz 
  • perfectly shielded against Alien Crosstalk and electromagnetic interference 
  • PoE Type 4 (100W) certified in FORCE Technology laboratories
  • suitable for a wide range of outlets, duct and channel systems 
  • applicable on cables with solid as well as stranded wires (guarantees anti-corrosive gas-tight joint) 

Technical specification

Suitable for installing on cables with solid wires from 0,51 to 0,64 mm (AWG 24 to AWG 22)
Suitable for installing on cables with stranded wires from AWG 26/7 to AWG 24/7
Required installation depth for sockets with angled faceplates 15 - 40 mm
Required installation depth for sockets with straight faceplates 40 mm
Contact pin material phosphor-bronze alloy coated with 50 μ of gold
Insertion / extraction cycles min. 750

Certificates and warranties


This product is certified on a component level by FORCE Technology international independent laboratories according to ISO/IEC 11801-1:2017 (Ed. 1.0) / ISO/IEC 11801-2:2017 (Ed. 1.0), IEC 60603-7-51:2010, EN 50173-1:2018 / EN 50173-2:2018, TIA-568.2-D:2018, IEC 60512-99-002:2019. 

Mass production of this product is under permanent supervision of third party international laboratories performing FORCE Technology EC VERIFIED quality audit of the manufacturer's production and quality assurance sites.



Examples of keystone jack compatibility with outlets of other manufacturers

Video tutorial

Related Products

10 Gigabit
10 Gigabit
10 Gigabit/s transmission speed, transmission of all standardized protocols including 10GBASE-T
Cat.6A
Cat.6A
meeting the requirements of performance category Cat.6A on a component level
500 Mhz
500 Mhz
Tested in bandwidth up to 500 MHz
PoE Type 4
PoE Type 4
PoE Type 4 (100W)
Keystone Jack, Category 6A, RJ45/s
P/N: KEJ-C6A-S-10G
  • tool-free, fast and easy installation 
  • suitable for a wide range of outlets, duct and channel systems
19” cable management panel with ring width of 37 mm, metallic
P/N: RAB-VP-X01-A2

  • provides horizontal cable management in the cabinet
  • set of M6 screws and captive nuts (4 pcs)


HD
HD
allows you to install 48 ports in 1U
19” cable management panel with ring depth of 73 mm, metallic
P/N: RAB-VP-X21-A2

  • provides horizontal cable management with double amount of patch cables in comparison with a standard cable management RAB-VP-X01-A2
  • suitable when using a HD patch panels with a density of 48 ports in 1U


Downloads
2019 © All rights reserverd.
Facebook
Have any question?
Product was added
Need an advice? Close
  1. Send
    Message has been sent.
Ask a question Close
  1. Send
    Message has been sent.